Fujitsu ST6012 - Stylistic Tablet PC User Manual page 64

To remove the battery from the Tablet PC:
1
Choose one of the following:
• If a charged battery is available, you can
suspend system operation. A built-in
"bridge" battery will maintain the system
in Sleep mode for about 5 minutes while
the battery is removed; this allows time
for replacement with a charged battery.
• If a charged battery is not available, save
your work and close all running programs,
then shut down the system or Hibernate.
• Plug in an external DC power source.
2
Slide the battery release latches in the direction indicated. (See Figure 13.)
3
Pull the battery away from the system, as shown in the illustration and remove the battery from the Tablet PC.
If you are using an external battery charger, refer to the instructions provided with the battery charger.
U F
NDER
THEM IN THE TRASH
REGULATIONS
To install the battery:
1
Orient the battery with the slides in the empty battery tray. Slide the battery into the tray and press it firmly until
it is seated. When it is properly seated, the battery release latches will return to position and lock the battery.
2
Once the battery is installed, you can resume system operation or start and use your system normally.
, ,
EDERAL STATE OR LOCAL LAW
. B
E SURE TO DISPOSE OF BATTERIES IN ACCORDANCE WITH LOCAL GOVERNMENT
.
64 - User-Installable Features
Release latch
Figure 13. Removing the battery
,
IT MAY BE ILLEGAL TO DISPOSE OF BATTERIES BY PUTTING
Release latch
Battery