Zone Alias Settings; Zone Settings - Dell PowerVault 50F User Manual

support.dell.com

Refresh button
Domain # field
Port # field
Port ID field
Port Type field
Port WWN field
Node WWN field
Symbolic Name field
FC4 Types field (not
shown in Figure 2-3)
COS field (not shown
in Figure 2-3)
Member of Zones field
(not shown in
Figure 2-3)
Done button
)  *% 
The Zone Administration consists of the following functions:

Zone Alias Settings

Zone Settings

Zone Config Settings
NOTE: You should make Zone Administration changes incrementally. Changes to
the zoning information are transferred to the switches only when you click Apply; if
you have made a large number of changes, the fabric can become unusable while the
information is being updated on all the switches in the fabric. Dell recommends that
you click Apply to update the changes frequently when modifying the zoning
information.
  
Click to refresh on demand
Displays the domain ID of a switch to which each device
is connected
Displays the port number of the switch
Displays the port ID of a device (Fibre Channel 24-bit ID
in hexadecimal)
Displays the port type of a device (N for fabric direct
attached port or NL for fabric direct attached loop port)
Displays the WWN for a device port
Displays the WWN for a device node
Displays the symbolic name of a device reported by the
SCSI INQUIRY command
Displays the Fibre Channel FC4 layer types supported
by device, such as IP and FCP
Displays the Fibre Channel classes of service supported
by the device
Lists all the zones of which the device is a member
Click to close the window
Using the Dell PowerVault Switch Manager


2-7