Automatic Preset Tuning - Yamaha GX-500RDS Owner's Manual

1 2
DISC DISC DISC
PTY SELECT
YMERSION B.BOOST MUSIC
MODE DOLBY NR REC/PAUSE
DIRECTION
1 2
1 2
6 7
6 7
A B
TIME PROG R. TIME
MODE REPEAT RANDOM
DISC SKIP
TUNER
REC/PAUSE
TAPE
YMERSION BASS BOOST
INPUT
1
POWER SLEEP
/I
Memory back-up
The memory back-up circuit prevents the programmed data
from being lost even if the AC supply lead is disconnected
from the AC outlet or the power is cut due to temporary
power failure. If, however, the power is cut for more than
one week, the memory may be erased. If so, it can be
re-programmed by simply following the Preset tuning steps.
3
DISC CHANGE OPEN / CLOSE
PRESET/ TUNING/ BAND A/B/C/D/E
VOLUME
DOWN UP
2
INPUT INPUT
FREQ PS/PTY/RT/CT MODE– PTY SEEK– START
RANDOM REPEAT TIME
HOUR MIN
AUTO/MANUAL MEMORY DISPLAY
TIMER TIME ADJ
3
STANDBY/ON
1
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
EDIT I0
TUNER
2
CD
DIRECTION
MUSIC
VOLUME
2

Automatic preset tuning

You can make use of an automatic preset tuning function. With
this function, the built-in tuner performs automatic tuning. Up
to 40 stations are stored automatically.
1
Turn on the power.
2
Press INPUT or until "TUNER" (
the display, or simply press TUNER on the remote control.
3
Press and hold MEMORY for more than 2 seconds.
6
* The "MEMORY" ( ) and "AUTO" (
The tuner performs automatic tuning and searches FM and
AM stations in that order. Received stations are programmed
to A1, A2 ... A8 sequentially.
When the automatic preset tuning is completed;
The display shows the frequencies of the first preset station
(stored to A1).
If you want to check the contents and the number of preset
stations, follow the procedure of the section "To recall a preset
station" on the previous page.
To recall a preset station
Simply follow the procedure of the section "To recall a preset
station" on the previous page.
Notes
The automatic preset tuning search will be performed
through all frequencies until 40 stations are stored. If the
number of received stations is less than 40, the search will
stop after searching all frequencies.
* Since FM stations are searched for first, there may be a
case that 40 preset stations are occupied by FM stations
only.
The tuner is originally set to search only RDS stations
instead of all FM stations by this operation. (FM stations
that employ no RDS network service cannot be
programmed.)
However, you can change the setting so that the tuner can
program not only RDS stations but also other FM stations.
(Refer to page 21 for details.)
With this function, only stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune in to it with the
Manual tuning method (in monaural) and program it by
following the procedure of the section "To store stations" on
the previous page.
You can replace a preset station with another FM or AM
station manually by simply following the procedure of the
section "To store stations" on the previous page.
Tuning operation
2 8
, ) appears on
4
) indicators flash.
E-17