Desa Comfort Glow CGCF26TP Owner's Operation And Installation Manual page 21

OPERATING
FIREPLACE
Continued
103667
4. Wait five (5) minutes to clear out any gas. Then smell for gas, including
near the floor. If you smell gas, STOP! Follow "B" in the safety information
at the top of page 19. If you don't smell gas, go to the next step.
5. Turn control knob counterclockwise
in control knob for five (5) seconds (see Figure 22, page 20).
You may be running this fireplace for the first time after hooking up
Note:
to gas supply. If so, the control knob may need to be pressed in for 30
seconds. This will allow air to bleed from the gas system.
• If control knob does not pop up when released, contact a qualified
service person or gas supplier for repairs.
6. With control knob pressed in, push down and release ignitor button. This
will light pilot. The pilot is attached to the front of burner. If needed, keep
pressing ignitor button until pilot lights.
If pilot does not stay lit, refer to Troubleshooting, pages 25 through
Note:
28. Also contact a qualified service person or gas supplier for repairs.
Until repairs are made, light pilot with match. To light pilot with match,
see Manual Lighting Procedure, page 22.
7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30
seconds, release control knob.
Thermocouple
If pilot goes out, repeat steps 3 through 7. This fireplace has a safety
Note:
interlock system. Wait one (1) minute before lighting pilot again.
8. Turn control knob counterclockwise
main burner should light. Set control knob to any heat level between HI
and LO.
Do not try to adjust heating levels by using the manual shutoff valve.
to the PILOT position. Press
C-clockwise
Ignitor Electrode
Pilot Burner
Figure 23 - Pilot
to desired heating level. The
C-clockwise
CAUTION
WARNING ICON G 001
21