Technical Service - Desa CEF26BN Safety Information And Installation Manual

Electric fireplace/insert with brushed nickel trim

Hide thumbs

Table Of Contents

Table of Contents

CLEANING AND

MAINTENANCE

Continued

4. Hold socket and push in new bulb (DO NOT

exceed wattage).

5. Replace spring clip onto bulb.

6. Repeat steps 3 through 5 for second bulb.

7. Gently push ember bed down until rear edge

is resting against rear ledge of unit.

8. Replace glass.

Flame Generation Bulbs

1. Carefully remove glass (see step 1 under

Cleaning Firebox Compartment, page 9).

2. From the bottom, gently pull forward and lift

up log set ember bed until front edge clears

the front of the unit (do not pull up on logs).

3. Loosen left and right screws/brackets that hold

glass in place. These are located at the bottom

of glass panel (see Figure 7).

4. With gloves and safety glasses in place, lift up

on bottom of glass by placing ﬁngers in notches

(see Figure 7) and pull forward. Place glass on

smooth, soft surface to avoid breakage.

5. Locate ﬂame generation cylindrical drum,

ﬁgure 8.

6. Squeeze half of drum cylinder until it's top

edge clears the top drum track. Remove bot-

tom edge of cylinder drum from bottom drum

track. This will give you access to the light

bulbs. Note: Do not exert excessive pressure

on drum cylinder as this may cause damage.

7. Remove spring clip. Hold socket and pull out

old bulb.

8. Hold socket and push in new bulb (DO NOT

exceed wattage). Replace spring clip.

Figure 7 - Glass and Bracket Location

Figure 8 - Flame Generation Cylinder