Steam Cleaning Hard Floors - Hoover Enhanced Clean WH20200 Owner's Manual

steaM CleaninG hard Floors

WARNING
!
Never leave the Steam Mop in one spot on any
surface for an extended period of time with a
damp or wet Microfiber pad attached as this
may damage the floor surface.
Your Steam Mop should only be used on tiles,
linoleum or sealed wood flooring. If used on
wax flooring, you may experience loss of
glossiness.
To reduce the risk of personal injury, unplug the
steamer when assembling the accessories.
Do not clean over floor electrical outlets.
Do not operate Steam Mop without water in
clean water tank.
Do not use unit or press the trigger with no
water in the tank.
IMPORTANT
Never use the Steam Mop without the
Microfiber pad properly attached to the floor
head.
„
Attach Microfiber pad.
power button on the steamer (2.13).
„
The unit will take roughly 30 seconds to be
ready to produce steam.
ready to be produced, the green "steam
ready" indicator will illuminate.
„
To recline the steamer place foot on floor
head and tilt handle (2.14).
„
To produce steam squeeze the trigger
„
Move the Steam Mop slowly backwards and
forwards across the floor (2.16) paying
particular attention to high traffic areas.
to disinfect
„
„
Turn Clean Control dial to HIGH.
„
Follow directions for steam cleanign hard
floors.
„
Run a minimum of 4 strokes at a medium
pace across same area and allow to air dry.
!
Plug in and press the
Once steam is
(2.15).
2.13
2.15
9
2.14
2.16