Product Identification; Local Codes - Desa VT32N Series Owner's Operation And Installation Manual

Direct-vent fireplace ng/lp “tudor” models

Hide thumbs Also See for VT32N Series:

Owner's operation and installation manual (44 pages)

Owner's operating and installation manual (38 pages)

Owner's operation and installation manual (38 pages)

Table Of Contents

Table of Contents

SAFETY INFORMATION

Continued

Do not modify this fireplace under any circumstances. Any

parts removed for servicing must be replaced prior to operat-

ing fireplace.

Turn fireplace off and let cool before servicing, installing, or

repairing. Only a qualified service person should install, ser-

vice, or repair this fireplace. Have fireplace inspected annu-

ally by a qualified service person.

You must keep control compartments, burners, and circulat-

ing air passages clean. More frequent cleaning may be needed

due to excessive lint and dust from carpeting, bedding mate-

rial, etc. Turn off the gas valve and pilot light before cleaning

fireplace.

10. Have venting system inspected annually by a qualified service

person. If needed, have venting system cleaned or repaired.

See Cleaning and Maintenance, page 28.

11. Keep the area around your fireplace clear of combustible ma-

terials, gasoline, and other flammable vapor and liquids. Do

not run fireplace where these are used or stored. Do not place

items such as clothing or decorations on or around fireplace.

12. Do not use this fireplace to cook food or burn paper or other

objects.

13. Do not use any solid fuels (wood, coal, paper, cardboard, etc.)

in this fireplace. Use only the gas type indicated on fireplace

nameplate.

14. This appliance, when installed, must be electrically grounded

in accordance with local codes or, in the absence of local codes,

with the National Electrical Code, ANSI/NFPA 70, or the Ca-

nadian Electrical Code, CSA C22.1.

15. Do not use fireplace if any part has been exposed to or under

water. Immediately call a qualified service person to arrange

for replacement of the unit.

16. Do not operate fireplace if any log is broken.

17. Do not use a blower insert, heat exchanger insert, or other ac-

cessory not approved for use with this fireplace.

18. Do not operate fireplace with glass door removed, cracked, or

broken.

19. Provide adequate clearances around air openings.

For more information, visit www.desatech.com

108661-01D