Marking the length of manual buttonholes
mark the buttonhole length in the desired position
█
use Buttonhole foot/sole no. 3 */**/***
█
Marking the length of automatic buttonholes
mark the length of just one buttonhole
█
after sewing the first buttonhole, the length for all subsequent buttonholes is
█
automatically programmed
mark only the beginning of all subsequent buttonholes
█
use Automatic buttonhole foot with slide no. 3A
█
Marking the length of keyhole buttonholes
mark the bead length only
█
the correct length eye will be added when the buttonhole is sewn
█
Test sewing
always sew a test sample on the fabric with stabilizer you intend to use
█
select the buttonhole type you intend to use
█
sew the buttonhole in the same direction on the fabric (horizontal or vertical,
█
with or against the grain)
cut the buttonhole open
█
push the button through
█
adjust the buttonhole length if necessary
█
To adjust the bead width
alter the stitch width
█
Altering the stitch length
stitch length adjustments affect both buttonhole beads (spacing between
█
the stitches)
reprogram the buttonhole length after changing the stitch length
█
Balance for automatic and manual buttonholes
Any balance alterations to the manual and auto-length buttonholes affect both
beads identically because they are sewn in the same direction.
If a buttonhole is sewn at right angles to the
fabric edge/fold, we recommend the use of
the height compensating plates for buttonho-
les (available as optional accessory).
Place the plates from the back between fabric
and bottom of slide foot up to the thick part of
the fabric and push to front.
When all buttonholes have been sewn,
return balance to the normal setting!
033301.70.04_1007_B330_B350_B380_EN
Sewing stitches - Buttonholes
37