--Nslookup, --Destination <Ip Address | Hostname; --Traceroute, --Destination <Ip Address | Hostname - Dell DR4000 Reference Manual

NOTE:
Ethernet network switch is capable of supporting an MTU size that is equal to
or larger than the value being set. Any mismatch in MTU values between the
clients, Ethernet network switch, and the DR4000 system will make it
inoperable.
CAUTION:
DR4000 system may be lost unless you are sure that the DR4000 system can
accept this bonding type.
If no options are specified, the following prompts are shown:
administrator@mydr4000 > network --setbonding
argument missing: --mode or --mtu is required
If you specified options, but did not provide values, you are prompted as
shown:
administrator@mydr4000 > network --setbonding --mode --mtu
--mode requires a value : --mode < ALB | 802.3ad > bond mode
to use. Valid modes: ALB or 802.3ad
--mtu requires a value : --mtu <number> bond MTU to use.
Valid range: 512 - 9000.
--nslookup, --destination <ip address | hostname>
To perform a DNS lookup for a DR4000 system, enter the example
commands string at the system prompt:
administrator@mydr4000 > network --nslookup --destination
10.25.20.15
10.25.20.15 has name sys-59.acme.storage.local.
If no options are specified, the following prompts are shown:
administrator@mydr4000 > network --nslookup
--destination missing: Destination IP address or hostname
--traceroute, --destination <ip address | hostname>
To perform a trace route for packets sent to a DR4000 system, enter the
example commands string at the system prompt:
administrator@mydr4000 > network --traceroute --destination
10.25.20.20
28
Managing the DR4000 System
When setting or changing the MTU value, make sure to verify that the
If the existing bonding setting is changed, the connection to the