Dell DR4000 Owner's Manual page 30

Message
No boot sector on
hard drive.
No timer tick
interrupt.
PCIe Training
Error: Expected
Link Width is
Actual Link Width
y
is .
Plug & Play
Configuration
Error.
Quad rank DIMM
detected after
single rank or
dual rank DIMM in
socket.
30
About Your System
Causes
Incorrect configuration
settings in System Setup
program, or no operating
system on hard drive.
Faulty system board.
Faulty or improperly
installed PCIe card in the
specified slot.
x
,
Error encountered in
initializing PCIe device;
faulty system board.
Invalid memory
configuration.
Corrective Actions
Check the hard drive
configuration settings in the
System Setup program.
See "Using the System Setup
Program and
UEFI Boot Manager" on
page 39. If necessary, install
the operating system on your
hard drive. See your
operating system
documentation.
See "Getting Help" on
page 149.
Reseat the PCIe card in the
specified slot number.
See "Troubleshooting
Expansion Cards" on
page 134. If the problem
persists, see "Getting Help"
on page 149.
Install the NVRAM_CLR
jumper in the clear position
(pins 1 and 3) and reboot the
system. See Figure 6-1 for
jumper location. If the
problem persists,
see "Troubleshooting
Expansion Cards" on
page 134.
Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module
Installation Guidelines" on
page 76.