Table of Contents
Advertisement
The blue-screen capture feature captures the video display contents before the IMM
restarts the server when the IMM detects an operating-system hang condition. A
system administrator can use the blue-screen capture to assist in determining the
cause of the hang condition.
Enabling the remote presence feature
To enable the remote presence feature, complete the following steps:
1. Install the virtual media key into the dedicated slot on the system board (see
2. Turn on the server.
Obtaining the IP address for the IMM
To access the Web interface, you need the IP address for the IMM. You can obtain
the IMM IP address through the Setup utility. The server comes with a default IP
address for the IMM of 192.168.70.125. To locate the IP address, complete the
following steps:
1. Turn on the server.
2. When the prompt <F1> Setup is displayed, press F1. (This prompt is displayed
3. From the Setup utility main menu, select System Settings.
4. On the next screen, select Integrated Management Module.
5. On the next screen, select Network Configuration.
6. Find the IP address and write it down.
7. Exit from the Setup utility.
Logging on to the Web interface
To log on to the Web interface to use the remote presence functions, complete the
following steps:
1. Open a Web browser on a computer that connects to the server and in the
2. On the Login page, type the user name and password. If you are using the IMM
"System-board optional-device connectors" on page 26).
Note: Approximately 1 to 3 minutes after the server is connected to ac power,
the power-control button becomes active.
Note: Approximately 1 to 3 minutes after the server is connected to ac power,
the power-control button becomes active.
on the screen for only a few seconds. You must press F1 quickly.) If you have
set both a power-on password and an administrator password, you must type
the administrator password to access the full Setup utility menu.
address or URL field, type the IP address or host name of the IMM to which
you want to connect.
Note: The IMM defaults to DHCP. If a DHCP host is not available, the IMM
assigns a static IP address of 192.168.70.125.
for the first time, you can obtain the user name and password from your system
administrator. All login attempts are documented in the event log.
Note: The IMM is set initially with a user name of USERID and password of
PASSW0RD (passw0rd with a zero, not the letter O). You have read/write
access. You must change the default password the first time you log on.
Chapter 3. Configuring the server
69
Advertisement
Table of Contents
