Displaying Gss System Configuration Information - Cisco GSS-4492R-K9 Administration Manual

Displaying GSS System Configuration Information

Displaying GSS System Configuration Information
Cisco Global Site Selector Administration Guide
2-44
Return the standby GSSM to its role as the original primary GSSM in the GSS
7.
network by entering the following command:
gssm1.example.com# gssm standby-to-primary
After entering the gssm primary-to-standby command, you should
Note
ensure that at least 1 minute passes before you enter the gssm
standby-to-primary command in order to allow time for proper GSS
device synchronization.
Configuration changes do not take effect immediately. It may take up to 10
minutes before the other GSS devices in the network learn about the new
primary GSSM.
You can now use the primary GSSM as in the original GSS network deployment.
The GSS CLI provides a comprehensive set of show commands that display GSS
configuration information. The show commands are available in all CLI modes.
This section contains the following topics:
• Displaying Software Version Information
Displaying License Information
•
Displaying Memory Information
•
Displaying Boot Configuration
•
Displaying GSS Processes
•
Displaying System Uptime
•
Displaying Disk Information
•
Displaying UDI Data
•
Displaying System Status
•
Displaying GSS Services
•
Chapter 2 Managing the GSS from the CLI
OL-10410-01