SETTING THE DEVICE
You can setup Camera, Storage Device, Remote Device, POS Device and Monitor.
Camera
Setting the Camera
You can set Video, Audio, Channel Name and Dwell Time of a Camera.
Using the mouse may help make setup easier.
1.
Press the [MENU] button on the remote control or front
panel.
Use the left/right button (◄ ►) to select <Device>.
2.
Device setting menu is selected.
3.
Use the up/down buttons () to move to <Camera>,
and press [ENTER] button.
4.
Select <Camera>.
You will see a window where you can configure the
camera settings including Video, Audio, Channel Name,
Dwell Time and Progressive.
Use direction buttons (◄ ►) to move to a desired
5.
item, and set the value.
•
Video
- <ON/OFF> : You can turn ON/OFF the selected
channel's camera.
- <Covert1> : Shows information other than the video of the selected channel.
For privacy protection, it does not display the video while the recording continues.
- <Covert2> : Shows nothing but an empty screen while the recording continues.
M
No signal will be output from channels that are set to <Covert1> or <Covert2> for the video.
However, audio recording will be performed for a channel whose audio is set to <ON> even if no audio signal is
output from the Live screen.
•
Audio
- If set to <ON>, you can turn the audio of the channel ON/OFF on the Live screen.
- If set to <OFF>, the channel's audio is off on the Live screen and not recorded.
Audio output is available for only 1 channel.
M
SRD-830DC/1610DC/1630DC supports 1~4 channels of sound inputs.
44_ using the DVR
Device
Camera
Storage Device
Remote Device
POS Device
Monitor
Camera
Camera
PTZ
CH
Video
Audio
CH Name
SEQ-Dwell Time
1
ON
OFF
CAM 01
5 sec
2
ON
OFF
CAM 02
5 sec
3
ON
OFF
CAM 03
5 sec
4
ON
OFF
CAM 04
5 sec
5
ON
OFF
CAM 05
5 sec
6
ON
OFF
CAM 06
5 sec
7
ON
OFF
CAM 07
5 sec
8
ON
OFF
CAM 08
5 sec
Screen Setup
OK
Cancel
Logout
Exit
Progressive
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Previous/Next Page