Awc Adjust Screen - JVC TK-AM200U - Active Movement Color Dome Camera Instructions Manual

Changing Camera Settings Using the RM-P2580
CAMERA VIDEO ADJUST Screen (Continued)
Item
COLOR Used to adjust the color level of the video sig-
LEVEL nal.
• To make colors lighter ... Decrease the value.
• To make colors darker ... Increase the value.
AWC
Pressing the SET button displays the AWC
ADJUST
(One-push Auto White Balance) adjustment
screen.
See "AWC ADJUST Screen" below.

AWC ADJUST Screen

The white balance compensation values set on this screen are retained in camera body.
To use the saved white balance compensation values, set the W. BALANCE item on the
VIDEO ADJUST FOR POSI screen to AWC. (
AWC A D J U S T
AD JU ST START > SET
AWC ADJUST screen
A WC O K
Normal screen
CAUTION:
• Even when the VIDEO ADJUST FOR POSI screen's W. BALANCE item is set to "ATW" or "MANUAL",
the AWC adjustment on the AWC ADJUST screen is effective and the value resulting from the
AWC adjustment is stored in the camera body.
However, when the positions set by "ATW" or "MANUAL" are selected again, the image returns from
the setting determined by the value resulting from the AWC adjustment to the setting values of
"ATW" or "MANUAL", respectively.
• AWC adjustment works separately for each position but only one adjustment value is stored, and
the value stored in the camera body is the value obtained when AWC adjustment was last performed.
22
Function
See page 23.)
1.
Select the AWC ADJUST item on the CAM-
ERA VIDEO ADJUST screen. When the SET
button is pressed, the AWC ADJUST screen
is displayed.
2.
Pressing the SET button on the AWC ADJUST
screen starts AWC (white balance adjust-
ment).
3.
When AWC adjustment is completed normally,
the compensation values are retained in the
camera body, and "AWC OK" is displayed on
the screen for about 3 seconds before the AWC
ADJUST screen returns.
The following indications are displayed if the
AWC adjustment is not accomplished correctly.
• OBJECT NG (improper object)
• HIGH LIGHT ERROR (excessive illumina-
tion)
• LOW LIGHT ERROR (insufficient illumina-
tion)
4.
To cancel the AWC operation, press the MENU
button before the operation is completed nor-
mally.
Variable Factory
range setting
0 5
(Integer
steps)
10