Table of Contents
Advertisement
Installation and Setup
Connecting Audio
Restore Factory Defaults
20
The alarm output can be configured to provide normally open or normally closed contacts
(see
Device Settings
on page
12 VDC @ 0.5 A.
The network camera supports bi-directional audio. There are two supported voice band
channels that function in full duplex mode. The camera can transmit audio from the camera
to the client (PC) using any audio source that provides an industry standard line level input
(3.5 mm jack). The camera can also receive audio from the client (PC) and provide an
industry standard line level output (3.5 mm jack) suitable to connect to audio devices. Audio
input and output have 600 Ohm impedance. See
audio options.
Your network camera has a Factory Reset switch on the side of the camera (see
Use this switch to restore your camera options and passwords to their default settings. Use
a pin or straightened paperclip to press and hold the Reset switch for three seconds.
37
to configure the alarm output). Contacts will be rated for
Audio Settings
on page
40
to configure
Figure
2-1).
Hide quick links:
Advertisement
Table of Contents
