Minolta MS6000 MK II Operator's Manual page 19

5
5.6 Odometer (Option)
The optional Odometer can be
used for image retrieval. When
a Cartridge is loaded in posi-
tion, the Odometer is reset to
"0000."
To reset the Odometer during a
retrieval sequence, depress the
CLEAR Button.
Depending on the setting, an Odometer count is equivalent in film length
to either:
12.7 mm (1/2 inch)
For this setting, consult your Tech. Service Rep. The Odometer
has been factory-set to 12.7 mm (1/2 inch) for one count.
5.7 Reel Shaft Release Lever
After the film has been rewind,
the Film Reel Shaft is not pulled
back out of the Cartridge Film.
Therefore, the Cartridge Film
cannot be slid out of Roll Film
Carrier. If this should occur,
push the Reel Shaft Release
Lever toward the rear side of
Roll Film Carrier.
10
or 30.5 mm (1/10 feet).
Reel Shaft Release Lever
Operation