Scanning A Photo; Scanning 35Mm Negatives - Kodak P460 User Manual

2. Wait until the power indicator stops blinking and then turns off. The Status/Card indicator will stay on steady,
indicating that the scanner is ready.
 Do not insert an original into the feed slot when the power indicator is blinking; the original will not be
scanned.

Scanning a Photo

1. Insert your photo into the plastic sheath (included with scanner).
Guide Lever
CAUTION: Do not scan glossy photos in humid environments (humidity higher than 70% RH); the surface of the photo will
become sticky and may cause the scanner to jam.
CAUTION: Insert only one photo at a time, and insert the next photo only when the previous one is done. Otherwise the
scanner may malfunction.
 Do not remove the memory card or disconnect the power supply while the indicators are blinking.
 This scanner produces JPEG (.jpg) file formats. The date/ time attribute will not be added.
 For more information on how this scanner stores the scanned picture files on the memory card, refer to "Orientation" on
page 7.
 If the memory card is nearly full (less than 1MB remaining), the Status/Card indicator blinks (refer to "Indicator Lights" on
page 5). Use another card or transfer pictures to your computer.
To turn off the scanner, press and hold the power button for one second. The power indicator will blink and
then go off.
Now you can safely disconnect the power and remove the memory card from the scanner.
 The scanner will automatically turn off if it's left idle for 15 minutes. (If it's connected to a computer, the scanner
will not automatically turn off.)

Scanning 35mm Negatives

 This scanner only supports the scanning of 35mm negative/monochrome 6-frame filmstrips, commonly available from your
local photo studios.
 Filmstrips in certain conditions are not suitable for scanning. Refer to Suitable and Unsuitable Original Types on
page 5.
Auto Image Mirror/Flip
The scanner can detect the orientation of a filmstrip when the printed numbers on the edge of the filmstrip are in the
same orientation as the picture.
If you feed the filmstrip with the image mirrored or upside-down, the scanner will automatically adjust the scanned
image during the scan.
8 Customer Support: http://www.pandigital.net/kodaksupport
2. With the photo facing upward and in correct orientation, place one edge of the photo on the scanner
and adjust the guide lever so that the photo aligns against the left side of the feed slot.
3. Insert the original level and flat into the feed slot.
The original will be fed through the slot and scanned automatically; the Power and Status/Card indicator
lights blink while scanning.
To prevent poor image quality, reserve adequate space behind the scanner for the photo to complete the
scan feeds.
When scanning is completed, the Power and Status/Card indicator lights blink while the scanner stores
the photo on the memory card.
Wait until the indicator lights stop blinking before inserting and scanning the next photo.