Driven Pulley Axle Support - PEUGEOT SATELIS - SERVICE MANUAL - BODY PANELS Service Manual

- First fit the specific tool stop ring on the pulley until the groove is fully in contact.
- Afterwards, insert the tool so that the studs on the ring fit the holes in the tool.
- Tighten, also manually, the two fixing nuts of the tool
- Unloose the central nut.
- Remove the cup washer and the plain washer.
- Remove the fixed driving half pulley.
- Remove the washer to bush connection.
- Move the belt downwards.
- Hold the roller stop plate, remove the mobile driving half pulley with its bush and rear washer, taking care
not to let the rollers come out.

Driven pulley axle support

- To be able to fit the specific tool for removal of the driven pulley shaft nut, unloose the 2 upper screws of
the driven pulley axle support.
- Manually turn the clutch housing as to partially uncover one of the holes in the driven pulley axle support.
29