Desa LSL18NT Safety Information And Installation Manual page 9

INSTALLATION
Continued
INSTALLING HEATER TO WALL
Mounting Bracket
Locate mounting bracket in heater carton. Remove
mounting bracket from heater carton.
Figure 5 - Mounting Bracket
Removing Front Panel Of Heater
1. Remove the four screws, two on each side of
front panel.
2. Pull front panel forward from the bottom, only
2 to 3 inches (5 to 7.6 cm).
3. Reach into lower right corner of heater and
disconnect ignitor wire.
4. Lift panel up to remove, set aside.
5. Remove any remaining packaging materials.
116292-01A
4. Turn front panel face down. Gently press onto
a hard surface to snap bushing into hole. Turn
panel back over, face up.
5. Place spacers over 4 holes on front panel as
shown in Figure 7.
6. Position glass on top of spacers, aligning holes.
Note: If glass gets scratched or marred from
normal use, it may be reversed on heater.
7. Place 4 retaining clips on glass over holes.
8. Install screws in each hole, but do not tighten
at this time.
9. Square glass up with top front surface of front
panel. Tighten screws.
10. Snap screw covers over retaining clips.
Screw Cover
Glass Panel
Figure 7 - Installing Glass Panel
www.desatech.com
Front
Panel
9