Installing Logs - Desa LDL3924PR Owner's Operation And Installation Manual

INSTALLATION
14

Installing Logs

INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HI, check to see if
flames contact any log. If so, reposition logs accord-
ing to the log installation instructions in this manual.
Flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not
modify logs. Only use logs supplied with heater.
1. Place rear log (log #1) behind burner on the two pins on rear
bracket (see Figure 20).
2. Place cutouts of middle log (log #2) on burner as shown in
Figure 21.
Figure 20 - Rear Log (Log #1) Placement
Cutout
Figure 21 - Middle Log (Log #2) Placement
For more information, visit www.desatech.com
For more information, visit www.desatech.com
3. Place left front log (log #3) on grate prongs as shown in Figure 22.
4. Place right front log (log #4) on peg of log #3 and grate prongs
as shown in Figure 22.
5. Place left crossover log (log #5) on pegs of log #2 and #3 (see
Figure 23). Place middle crossover log (log #6) on pegs of log
#1 and #2 (see Figure 23). Place right crossover log (log #7)
on pegs of log #2 and #4 (see Figure 23).
6. Slide control cover log (log #8) into place between front logs
#3 and #4 (see Figure 24).
Peg
Log #1
Figure 22 - Placement of Front Logs (Log #3 and Log #4)
Log #5
Log #2
Figure 23 - Placement of Crossover Logs (Logs #5, #6, and #7)
Cutout
Log #8
Figure 24 - Control Cover Log (Log #8) Placement
Log #3
Grate
Prongs
Log #6
Log #4
Log #7
111515-01C