Storage; Preventative Maintenance Schedule; To Stop Heater; To Restart Heater - Master H.S.I. Series Owner's Manual

OPERATION
Continued

STORAGE

PREVENTATIVE
MAINTENANCE
SCHEDULE
8
Flame-Out
Control
Reset Button
(Fan Guard
Removed)
Figure 8 - Flame-Out Control Reset Button, 150,000 BTU/Hr EDI Model

To Stop Heater

1. Unplug power cord from outlet.

To Restart Heater

1. Wait 2 minutes after stopping heater.
2. Repeat steps under To Start Heater, page 7.
1. Drain fuel tank.
Some models have drain plug on underside of fuel tank. If so, remove
Note:
drain plug to drain all fuel. If heater does not have drain plug, drain fuel
through fuel cap opening. Be sure all fuel is removed.
2. Replace drain plug if used.
3. Add one gallon (4 liters) of clean kerosene to fuel tank.
4. Attach fuel cap.
5. Move heater forwards and backwards to stir fuel.
6. Remove fuel cap or drain plug and drain fuel tank. Be sure all fuel is removed.
7. Replace fuel cap or drain plug. Properly dispose of old and dirty fuel.
8. Store heater in dry place. Make sure storage place is free of dust and corrosive
fumes.
IMPORTANT: Do not store kerosene over summer months for use during next
heating season. Using old fuel could damage heater.
Never service heater while it is plugged in, operating, or
hot. Severe burns and electrical shock can occur.
Item How Often
Fuel tank Flush every 150-200 hours
of operation or as needed.
Air output and Replace every 500 hours of
lint filters operation or once a year.
Air intake Wash and dry with soap and
filter water every 500 hours of
operation or as needed.
Fuel filter Clean twice a heating season
or as needed.
WARNING
How To
See Storage above.
See Air Output, Air Intake,
and Lint Filters, page 14.
See Air Output, Air Intake,
and Lint Filters, page 14.
See Fuel Filter, pages 10
and 11.
Continued
099605