INSTALLATION
16
Installing Logs (Cont.)
INSTALLATION
Continued
Log #2
Log #1
Front Post
Chassis
Figure 22 - Installing Vintage Oak Two-Piece Log Set
Burner Ports
Figure 23 - Installing Vintage Oak Two-Piece Log Set (Top View)
Golden Oak One-Piece Log Set
1.
Place one-piece log set on grate to fit as illustrated in Figure
24. Make sure middle section at bottom of log set is seated
into "U"-shaped cutouts in center of chassis (see Figure 24).
IMPORTANT: Make sure log does not cover any burner ports
(see Figure 25).
2.
Place lava rock around base of heater if desired.
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Rear Post
Two Piece
Log Set
Five Piece
Log Set
Chassis
Figure 24 - Installing Golden Oak One-Piece Log Set
Burner Ports
Figure 25 - Installing Golden Oak Log Sets (Top View)
Middle Section
at Bottom of
Log Set
Burner
"U"-shaped Cutout
in Chassis
Log Set
110399-01B