Desa FLAME-MAX FLAME-MAX VintageOak Operation And Installation Manual page 12

INSTALLATION
12
Installing Heater Base Assembly (Cont.)
INSTALLATION
Continued
4. Place logs in their proper position on heater base (see Installing
Logs, pages 15 through 17).
5. Center heater base and logs front-to-back and side-to-side in
fireplace.
6. Carefully remove logs without moving heater base.
7. Mark screw locations through one hole on each side of the
mounting bracket (see Figures 13, 14 or 15, depending on your
model). If installing in a brick-bottom fireplace, mark screw
locations in mortar joint of bricks.
8. Remove heater base from fireplace. If installing optional con-
trol accessories, do so at this time (Remote-Ready Models
Only). Follow all directions provided with accessory.
9. Drill holes at marked locations using 3/16" drill bit.
10. Attach base assembly to fireplace floor using two masonry
screws (in hardware package).
Flexible Gas Hose (if
allowed by local codes)
Figure 11 - Attaching Flexible Gas Hose to Heater Gas
Regulator (Variable Manually-Controlled and Thermostat-
Controlled Models Only)
Figure 12 - Attaching Flexible Gas Hose to Heater (Remote-
Ready Models Only)
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Heater Gas
Regulator
Fitting
Flexible Gas
Hose (if allowed
by local codes)
Fitting
VINTAGE OAK LOG CHASSIS
(Variable Manually-Controlled and
Thermostat-Controlled Models)
Figure 13 - Attaching Heater to Fireplace Floor (Variable Manually-
Controlled and Thermostat-Controlled Models Only)
GOLDEN OAK MODEL CHASSIS
(Variable Manually-Controlled and
Thermostat-Controlled Models)
Figure 14 - Attaching Base to Fireplace Floor (Remote-Ready
Models Only)
GOLDEN OAK MODEL CHASSIS
(Remote-Ready Models)
Figure 15 - Attaching Base Assembly to Fireplace Floor
Masonry
Screw
Bracket with
Screw Holes
Masonry
Screw
Bracket with
Screw Holes
Masonry
Screw
Bracket with
Screw Holes
110399-01B