Encore ENTC-1000 - V1.04 User Manual page 31

2) Open and edit
editor. Look for lines similar to the following text,
# Allow remote access to your display manager (kdm
only for now)
#
DISPLAYMANAGER_REMOTE_ACCESS="yes"
The last line specifies whether KDM should allow remote
connections. If this line says "no" on your system, modify it to
"yes" and save your changes.
3) Open and edit
with a text editor. Look for lines similar to the following text,
[Xdmcp]
# Whether KDM should listen to XDMCP requests.
Default is true.
Enable=true
# The UDP port KDM should listen on for XDMCP
requests. Don't change the 177.
Port=177
These lines specify that KDM should enable XDMCP service. If
the lines say otherwise on your system, modify them and save
your changes.
4) Make sure your Linux server starts in graphical mode. If your
system starts in text mode, you need to change the default
"runlevel" to 5.
Open and edit
similar to the following text,
/etc/sysconfig/displaymanager
/etc/opt/kde3/share/config/kdm/kdmrc
/etc/inittab
Page 31 of 51
Copyright © 2007 Encore Electronics, Inc.
ENTC-1000 Encore Thin Client
file with a text editor. Look for a line
User Manual v1.0
file with a text
file