Crossovers (Filters); High Pass Filter; Low Pass Filter; Subsonic Filter - DLS RA50 How To Install And Operate

Crossovers
The DLS RA50 amplifier include high pass filter (HP),
low pass filter (LP) and subsonic filter.
The slope of all filters are 12 dB / octave (subsonic 18
dB). The filters can be switched off if you want to run
the amplifier in full range mode. Some of the filters
can be used on different frequency ranges by the use
of multiplication switches.
The filter configuration on the respective channels can
be found in the technical specifications.

High Pass Filter

The HP-filter ( high pass filter )
blocks very low frequencies from
reaching the speakers. It is
mostly used at say 60 Hz to
protect small speakers ( like 6
inch and smaller ) from deep
bass.

Low Pass Filter

The LP-filter ( low pass filter) is
mostly used for subwoofers. It will
allow low frequencies only and
blocks higher frequencies.
A typical setting is 50 – 80 Hz.
The filter can be switched IN-OUT.
The LP-filter on ch 1&2 has an-
other frequency range used for
other applications.

Subsonic filter

The subsonic filter is used to take
away the very deepest
frequencies from a bass box.
The x-over frequency is 25 Hz.
Filters on CH 1 and CH2
CH1 and CH2 include high pass filter (HP) and low
pass filter (LP).
The slope of the filters are 12 dB / octave. The filt-
ers can be switched off if you want to run the
amplifier in full range mode.
The LP-filter can be used in two different frequency
ranges by changing a switch in the bottom plate of
the amplifer. The switch has two positions giving
the following frequency ranges:
x1 = 250 - 700 Hz
HP-filter
x10 = 2,5 kHz - 7 kHz
FREQUENCY
The LP-filter is used when running a 2- or 3-way
system in active mode. See the examples later in
50 140
the manual.
Hz
Switches
in bottom
plate
LP-filter
FREQUENCY
The HP-filter is adjustable between 50 - 140 Hz. It
40 125
blocks very low frequencies from reaching the
Hz
speakers. It is mostly used at say 60 Hz to protect
small speakers ( like 6 inch and smaller ) from deep
bass.
IN
OUT
CH1 CH2 LP filter
Frequency selector
x1
250 - 700 Hz
x10
2,5 - 7 kHz
RA50
7