DLS ULTIMATE TA2 Owner's Manual

How to install and operate the
DLS ULTIMATE TA2
2-channel Tube Amplifier
Welcome!
This owners manual is written in easy english and
uses a lot of drawings to simplyfy the installation
and use of the above amplifiers.
Your DLS amplifier must be installed correctly in order
to work well. This manual will show you how to install
the amplifier like a pro. Please read the entire manual
before beginning the installation.
Install the amplifier yourself if you feel confident with
our instructions and if you have the proper tools.
However if you feel unsure, turn over the installation
job to someone better suited to it.

Warranty Service

This amplifier is covered by warranty, depending on
the conditions in the country where it is sold. If the
amplifier is returned for service, please include the
original dated receipt with the product.

Technical Assistance

For technical assistance ask the shop where the
product was sold or the distributor in your very coun-
try.
You can always phone the DLS Helpdesk in Sweden
+ 46 31 84 00 60 or send an e-mail to info@dls.se.
Information can also be found on our WEB-site
www.dls.se
Contents
Features.....................................
Installation..................................
Tools and materials needed..........
Wiring
Power and speakers....................
Inputs & controls.........................
Crossovers..................................
Testing.........................................
Trouble-shooting............................
Professional tips............................
System drawing.............................
SPECIFICATIONS
RMS output per channel at 13,8 volts,
20 Hz - 20 kHz , < 0,1% distortion.
Number of channels
Working mode
Output power in 4 ohm
Output power in 2 ohm
Tubes in signal path
THD@ 1W
Frequency response +/- 0,5 dB 10 Hz - 50 kHz
S / N ratio, A-weighted
Damping factor
Input impedance
High pass filter
Filter slope
Input sensitivity
Max cable size Dc input
Max cable size, speakers
Fuses
Ptotection
Amplifier warm-up time
Power consumption:
Supply voltage
Idle
Maximum
Dimensions (mm) W x H x D
Dimensions (inch)
Weight
We follow a policy of continuous advancement in
development.
For this reason all or part of specifications &
designs may be changed without prior notice.
2
2
2
3
4
4
5
5
6
7
2
AB
2x100 W
2 x 200 W
2 x CV4010
<0,04%
>102 dB
>240
>10k
20 - 200 Hz
12 dB/octave
0,5 - 7V
2
16 mm (AWG5)
2
16 mm (AWG5)
20A x 2
Current & thermal
45 seconds
12-14 V DC
1,5 A
40 A
410x240x73
" 16,14x9,45x2,87
6,2 kg ( 13,67 lb)