Specifications - DLS RA50 How To Install And Operate

Reference series 5-channel amplifier
Hide thumbs Also See for RA50:
Table of Contents

Advertisement

Specifications

DLS REFERENCE
Number of channels
Working mode
Power output at 13,8 Volt, 20 Hz - 20 kHz, max 0,1 % THD, all channels driven.
RMS power out in 4 ohm
RMS power out in 2 ohm
THD @1 W
Signal to noise ratio, A-weighted
Damping factor
Frequency response +/- 0,5 dB
Input impedance, low level
Input impedance, high level
High level input with auto start
Input sensitivity
Filter slope
* can be switched Low/High level and Auto Start
Pre amp configuration on Front channels:
Filter high pass
Filter Low pass
** can be switched in/out
Pre amp configuration on Rear channels:
Filter high pass
** can be switched in/out
Pre amp configuration on RA50 sub channel:
Filter lowpass
Fixed subsonic filter
Phase shift 0-180 degrees continously
Grand bass adjustable gain @ 40 Hz
Remote bass level and phase control
*** can be switched in/out
Protection
Max cable size, DC input
Max cable size, front speakers
Max cable size, sub output
Power consumption:
Idle
Maximum
Fuse
Dimensions HxWxD(mm)
Dimensions (inch)
Weight
NOTE!
Channel 1 - 4 amplifiers are 2 ohm stable. You can
connect loads down to 2 ohm on each channel.
When connecting in mono bridge mode (CH1-2 &
CH 3-4) it is possible to connect one 4 ohm speaker
on each channel pair. In bridge mode connection an
amplifier sees a 4 ohm speaker as a 2 ohm load.
The sub channel on RA50 can handle 2 ohm loads,
for example two 4 ohm subwoofers in parallel.
We follow a policy of continuous advancement in
development.
For this reason all or part of specifications & designs
may be changed without prior notice.
RA50
5
AB
4 x 70 W + 1 x 265 W
4 x 110 W + 1 x 365 W
< 0,1%
>100 dB
>200
10 Hz - 50 kHz
>10 kohm*
330 ohm*
Yes
0,5 - 8V
12 dB / octave
50 - 140 Hz**
250 - 700 Hz** (Freq. x 1, x 10 switch)
50 - 140 Hz** (Freq. x 1, x5, x50)
40 - 125 Hz
25 Hz, 18 dB/octave filter slope***
Yes
0 - +18 dB
Yes***
current, thermal & DC offset
4 AWG, 21 mm
2
2
10 AWG, 6 mm
7 AWG, 10 mm
2
1,2 A
90 A
3 x 30 A, ATC-type
59x479x245
2,33x18,855x9,65
5,5 kg / 12,1 lb
RA50
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents