Step 3: Unpacking And Moving The Range - Thermador PRD486JDGU Installation Manual

Pro grand prd36, prd48 series dual fuel ranges
Hide thumbs Also See for PRD486JDGU:
Table of Contents

Advertisement

Available languages

Available languages

Electrical Supply
Installation of the range must be planned so that the rough-
in of the terminal block for the receptacle or conduit
connection will allow maximum clearance to the rear of the
unit.
When the power supply cord or conduit is connected to the
mating receptacle or terminal block cover, the combined
connection should protrude no more than 2"(51mm) from
the rear wall (see Figure 4).
Refer to Figure 11 on page 16 for location of the terminal
block on unit. To minimize binding when the unit is
connected, orient the receptacle or conduit connector, and
slide back into position.
2" (51mm)
maximum
2" (51mm) maximum
when plugged in
English 8
Figure 4: Wall Connection
Step 3: Unpacking and Moving
the Range
CAUTION:
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least two
people must be used in moving the range to
avoid injury and to avoid damage to the unit or
the floor. Rings, watches, and any other loose
items that may damage the unit or otherwise
might become entangled with the unit should be
removed.
Hidden surfaces may have sharp edges. Use
caution
when
appliance.
The range has an approximate shipping weight as shown in
"Chart A". The grates, griddle plate, burner caps, and oven
racks must be removed to facilitate handling. Do not
remove the griddle element and tray assembly.
1. Remove the outer carton and packing materials from
the shipping pallet but leave the adhesive-backed foam
layer over brushed-metal surfaces, to protect finish
from scratches, until the range is installed in its final
position.
2. Remove the door(s) (see "Step 4: Door Removal and
Reinstallation" on page 10); however, do not remove
the warming drawer or steam oven doors. This will
create an estimated reduction in the weight as shown
in "Chart A" and allow the range to pass through 30"
(762mm) doorways (see clearances shown on page 6).
Chart A
Shipping Weight
Weight without packing
materials
Without door(s), burner caps,
and oven racks
Caution
DO NOT lift the range by the oven door's handle,
as this may damage the door hinges and cause
the door to fit incorrectly.
reaching
behind
or
36"
48"
Range
Range
420 lbs
590 lbs
(191 kg)
(268 kg)
360 lbs
530 lbs
(163 kg)
(240 kg)
260 lbs
390 lbs
(118 kg)
(177 kg)
under

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prd48jdsguPrd364jdguPrd366jgu

Table of Contents