Download Print this page

Important Instructions - Kenmore 4102 - Elite 30 in. Slide-In Electric Range Installation Instructions Manual

30" electric slide-in range
Hide thumbs Also See for 4102 - Elite 30 in. Slide-In Electric Range:

Advertisement

Available languages

Available languages

Important
Notes
to the
Installer
1.
Read all instructions contained in these installation
instructions before installing range.
2.
Remove all packing material from the oven and the
drawer compartments before connecting the electrical
supply to the range.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with the consumer.
Important
Note
to the
Consumer
Keep these instructions with your owner's guide for future
reference.
IMPORTANT
SAFETY
INSTRUCTIONS
• Be sure your
range
is installed
and grounded
properly
by a qualified
installer
or service
technician.
• This range must
be electrically
grounded
in
accordance
with
local codes
or, in their
absence,
with
the National
Electrical
Code ANSI/NFPA
No.
70--latest
edition.
The installation
of appliances
designed
for
manufactured
(mobile)
home installation
must conform
with Manufactured
Home Construction
and Safety
Standard,
title 24CFR, part 3280 [Formerly
the Federal
Standard
for Mobile
Home Construction
and Safety,
title 24, HUD (part 280)] or when such standard
is not
applicable,
the Standard
for Manufactured
Home
Installation
1982 (Manufactured
Home Sites,
Communities
and Setups), ANSI Z225.1/NEPA
501A-
latest edition,
or with local codes.
• Make
sure the wall
coverings
around
the range
can withstand
the heat
generated
by the range.
• Before
installing
the range
in an area covered
with
linoleum
or any other
synthetic
floor
covering,
make
sure
the floor
covering
can
withstand
heat at least 90°F above
room
temperature
without
shrinking,
warping
or
discoloring.
All ranges
can tip.
Injuryto
persons could
result.
Install anti-tip
device
packed with
range.
To reduce
the risk of tipping of the
range, the range must be
secured by properly
installed anti-tip bracket
(s) provided with the
range. To check if the
bracket (s) is installed
properly, grasp the top
rear edge of the range
and carefully tilt it
forward to make sure the
range is anchored.
Do not install the range over carpeting unless you place
an insulating pad or sheet of I/4" thick plywood
between the range and carpeting.
Never leave children
alone or
unattended
in the area where an appliance
is in use.
As children grow, teach them the proper, safe use of all
appliances. Never leave the oven door open when the
range is unattended.
Stepping,
leaning
or sitting
on the
door or drawer
of this range can result in serious
injuries and can also cause damage to the range.
• Do not store items of interest
to children
in the
cabinets above the range. Children could be seriously
burned climbing on the range to reach items.
To eliminate
the risk of burns or fire by reaching
over heated surface units, cabinet storage space
above the surface unit should be avoided.
If
cabinet storage is to be provided the risk can be reduce
by installing a range hood that project horizontally a
minimum of 5 inches beyond the bottom of the
cabinet.
• Do not use the oven as a storage space. This
creates a potentially hazardous situation.
• Never use your range for warming
or heating
the
room. Prolonged use of the range without adequate
ventilation can be dangerous.
• Do not store or use gasoline
or other flammable
vapors and liquids
near this or any other
appliance.
Explosions or fires could result.
• Reset all controls
to the "off"
position
after using
a programmable
timing
operation.
FOR MODELS WITH SELF-CLEAN FEATURE:
• Remove broiler pan, food and other utensils
before self-cleaning
the oven. Wipe up excess
spillage. Follow the pre-cleaning instructions in the Use
and Care Guide.
Power
Supply Cord Kit
The user is responsible for connecting the power supply
cord to the connection block located behind the back
panel access cover.
This appliance may be connected by means of
permanent "hard wiring" ; flexible armored or
nonmetallic shielded copper cable (when local code
allow it) or by means of a power supply cord kit. See
chart (on next page) for the minimum wire size (general
UL listing, local code may differ).

Advertisement

loading

This manual is also suitable for:

4102 30