Product Identification - Desa B110BT Owner's Manual

PRODUCT
IDENTIFICATION
Hot Air
Outlet
Lower
Shell
Fuel
Cap
Side Cover
Ignition Control
Assembly (assembly on
inside of side cover)
Figure 1 - Portable Forced Air Heater
ASSEMBLY
These models are furnished with wheels and
a front handle. Some models are furnished
with a rear handle also. Wheels, handle(s),
and the mounting hardware are found in the
shipping carton.
TOOLS NEEDED
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support frame.
Install wheels on axle.
IMPORTANT: When installing wheels,
point extended hub of wheels toward
wheel support frame (see Figure 2).
2. Place cap nuts on axle ends. Gently tap
with hammer to secure.
3. Place heater on wheel support frame.
Make sure air inlet end (rear) of heater is
over wheels. Line up holes on fuel tank
flange with holes on wheel support frame.
4. Place front handle (and rear handle if pro-
vided) on top of fuel tank flange. Insert
screws through handle(s), fuel tank flange,
and wheel support frame. Attach nut
finger tight after each screw is inserted.
5. After all screws are inserted, tighten
nuts firmly.
104192
Thermostat Knob
Upper Shell
Fan Guard
Power Cord
Hot Air
Outlet
Fuel
Tank
Flange
Wheel
Support
Frame
Wheel
Cap Nut
Figure 2 - Wheel and Handle Assembly
OWNER'S MANUAL
Fuel Tank
Front
Handle
Screw
Nut
3
Rear
Handle
Air Inlet
Extended Hub
Axle