Ws2A - Martin Audio W0.5 Manual

Wavefront professional series
Hide thumbs Also See for W0.5:
Table of Contents

Advertisement

<
CONTENTS
3.2
The W1 is an ultra-compact passive two-way system with a high output
capability for its small size. Featuring a 10" (250mm) bass driver and 1"
(25mm) compression driver on a 70 x 40 degree horn, it is particularly
useful in distributed sound and audio-visual appplications.
3.3
The W2 is a powerful stand-alone system combining dynamic full-frequency
performance with exceptional articulation. Designed to meet the industry
standard requirement for a 12" (305mm) bass driver plus 70 x 40 horn
combination, the W2 can be configured as either an active or passive
system by means of a switch on the rear of the enclosure.
3.4
The W3 is an innovative full-range system achieving true three-way
performance from an enclosure only 28" (711mm) high. The low frequency
driver is a powerful 15" (380mm) device cooled by a heat exchange system
to reduce power compression. Midrange is produced by a unique 6.5"
(165mm) mid horn developed to overcome the power and distortion
limitations of traditionally used large format compression drivers whilst high
frequencies are produced by a 1" (25mm) compression driver. Mid and HF
dispersion patterns are 65 x 40 degrees. The W3 is a three-way system
designed for bi-amplification at its 650Hz low/mid crossover point. A fully
passive version, the W3P is available for situations which require simplicity
and reduced amplifier count.
3.5
Where a Wavefront Professional Series enclosure requires additional low
frequency enhancement, the WS2A will extend the power bandwidth of the
system to below 35Hz. It utilises twin high power 15" (380mm) drivers with
4" (100mm) voice coils in an optimally tuned compact reflex enclosure.
NOTE:
Passive systems such as the W0.5, WM0.5, W1, W2 (in passive mode) and
W3P may be used without a WX3A controller provided recommended
amplifier power is not exceeded and care is taken to avoid amplifier
clipping. Use of an optional WX3A controller with its system specific low
frequency EQ and built in limiters will result in improved bass response and
system protection.
All material © 2007. Martin Audio Ltd. Subject to change without notice.
Martin Audio – WAVEFRONT PROFESSIONAL SERIES
>
PRINT
W1
W2
W3 and W3P

WS2A

3
GUIDES

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

W1W2W3Wm0.5Ws2aW3p

Table of Contents