2.3.5
Max mains current
The Max mains current screen is shown below. The "+" and "-" buttons change the value of the max mains
current input in the range from 15 to 32A.
2.3.6
Clip limiter CH1 - CH2
Enable this function to prevent the distortion due to excessive amplitude of output signal. You can
enable/disable it by pushing the on/off button.
CAUTION: There is the risk of damage to the loudspeakers, if Clip Limiters are deactivated. You
should not deactivate Clip Limiters unless their function is taken over by external devices, such as
digital system controllers. In such cases it is mandatory, to properly adjust parameters in the
external device.
2.3.7
Gate CH1 - CH2
This function allows to mute the amplifier channels individually if input signal amplitude is falling below the
values shown in the following table. You can enable/disable it by pushing the on/off button. Gating the output
is delayed by 5 seconds after input signal removal, and follows in reversed way the bottom green LED on the
CH1, CH2 bar LED display *(muted if green LED is off).
2.3.8
KETH
This section is not currently implemented.
2.3.10 Bar meters
In the Bar meters screen you can choose if the LED bars operate as output voltage meter and LCD bar in
the main screen as output current meter (by selecting "LED Volt, LCD Curr), or vice versa (by selecting the
other item).
All material © 2007. Martin Audio Ltd. Subject to change without notice.