Loudspeakers; Connecting Loudspeakers To The A28 - Arcam FMJ A28 Handbook

loudspeakers

Connecting loudspeakers to the A28

Single wiring
Single wiring is the conventional wiring method of
running a single cable per channel between the amplifier
and the speaker; this is the easiest technique.
bi-wiring
Bi-wiring is running two separate cables between the
amplifier and each speaker, with one cable carrying
the low-frequency information, the other the higher-
frequency signals.
Bi-wiring can improve the sound of your system because
the separation of high- and low-frequency signal
currents into different speaker cables avoids distortions
caused by the different currents interacting with one-
another within a single cable.
The A28 is designed to allow easy bi-wiring, but your
loudspeakers need to provide separate terminals for
the two cables. Each speaker must have two pairs of
terminals; one pair labelled or 'High Frequency' , the
hF
other pair labelled or 'Low Frequency' .
LF
bi-amping
Bi-amping is the separation of the amplification of low-
and high-frequency signals over two amplifiers.
Bi-amping requires the use of two amplifiers per
channel. Normally, your A28 is used to drive the high-
frequency (treble) speakers, with a P38 used for the
lower (bass) frequencies.
notes on making speaker
connections
Do not make any connections to any amplifier
<
while it is switched on. We recommend that
your amplifier is completely disconnected
from the mains supply before starting.
Before switching your amplifier(s) on for the
<
first time after connecting to speakers, please
check all connections thoroughly. Ensure
that bare wires or cables are not touching
each other or the amplifier's chassis (which
could cause short circuits), and that you
have connected positive (+) to positive and
negative (–) to negative. Be sure to check the
wiring for both the amplifier and the speaker.
After making connections: switch the
<
amplifier(s) on, select a source signal, then
gradually increase the volume to the required
listening level.
If you are unsure as to how your system
<
should be connected, or need advice on
bi-wiring or bi-amping, please contact your
Arcam dealer who will be happy to help you.
e-8