Checking The Currently Playing Program Source, Etc - Denon AVR-5805CI Operating Instructions Manual

Basic Operation
ANALOG SURROUND PARAMETER
EXT. IN
INPUT MODE
DIMMER
Checking the currently playing program
source, etc.
On screen display
2
ON SCREEN
Press the
Each time an operation is performed, a description of
that operation appears on the display connected to AVR-
5805CI's VIDEO MONITOR OUT terminal. Also, the
unit's operating status can be checked during playback.
Such information as the position of the input selector
and the surround settings is output in sequence.
Front panel display
2
STATUS
Press the button.
Descriptions of the unit's operations are also displayed
on the front panel display. In addition, the display can be
switched to check the unit's operating status while
playing a source.
Using the dimmer function
2
• Use this to change the brightness of the display.
DIMMER
Press the button.
The display brightness changes in four steps (bright,
medium, dim and off).
Input mode
• The AVR-5805CI has an AUTO signal detection mode that
automatically identifies the type of incoming audio signals,
but is also equipped with a manual mode that can be
switched according to the type of input audio signals.
STATUS
CURSOR
button.
CURSOR
SURROUND
PARAMETER
Selecting the AUTO, PCM and DTS modes
2
INPUT MODE
Press the
The mode switches as shown below each time the
INPUT MODE button on the main unit is pressed:
AUTO
When operating the remote control unit:
(Remote control unit)
The mode switches as shown below each time the
INPUT MODE button on the remote control unit is
pressed:
AUTO
EXT.IN -2
AUTO (All auto mode):
In this mode, the types of signals being input to the
digital and analog input terminals for the selected input
source are detected and the program in the AVR-
5805CI's surround decoder is selected automatically
upon playback. This mode can be selected for all input
sources other than PHONO and TUNER.
The presence or absence of digital signals is detected,
the signals input to the digital input terminals are
identified and decoding and playback are performed
automatically in DTS, Dolby Digital or PCM (2 channel
stereo) format. If no digital signal is being input, the
analog input terminals are selected.
Use this mode to play Dolby Digital signals.
PCM (exclusive PCM signal playback mode):
Decoding and playback are only performed when PCM
signals are being input.
Note that noise may be generated when using this
mode to play signals other than PCM signals.
DTS (exclusive DTS signal playback mode):
Decoding and playback are only performed when DTS
signals are being input.
46
INPUT MODE
ON SCREEN
button.
PCM DTS
PCM DTS
EXT.IN -1 ANALOG