Connecting A Turntable; Connecting A Cd Recorder Or Md Recorder - Denon AVR-5805CI Operating Instructions Manual

Connecting Other Sources

Connecting a turntable

• You can connect the turntable (MM cartridge) to the PHONO terminals.
NOTE:
• The phono input can accept signals from moving magnet (MM) and high output moving coil (MC) phono cartridges. If your
turntable is equipped with a low output MC cartridge, you will need to use a separate MC head amplifier or step-up MC
transformer.
• If humming or other noise is generated when the ground wire is connected to the SIGNAL GND terminal, disconnect the
ground wire.

Connecting a CD recorder or MD recorder

• If you wish to perform analog dubbing from a digital source, such as a CD or MD recorder to an analog recorder such as a
cassette deck, you will need to connect analog inputs and outputs as shown below, in addition to the digital audio connections.
NOTE:
• Do not connect the output of the component connected to the OPTICAL 5 OUT terminal on the AVR-5805CI's rear panel
to any terminal other than the OPTICAL 5 IN terminal.
A
L
R
A
L
R
A
L
R
D
D
34
Turntable
(MM cartridge)
AUDIO OUT
GND
CD recorder /
MD recorder
AUDIO OUT
L
L
R
R
AUDIO IN
L
L
R
R
OPTICAL
OUT
OPTICAL
IN