HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade User Manual page 47

Problem 15
A firmware upgrade is unsuccessful, causing the controller to hang.
Solution 15
The new firmware can be temporarily disabled and the upgrade attempted again by
following the steps below:
1. Power-off the system.
2. Place shorting jumpers across pins 1 and 2 and pins 3 and 4 of P9 on the
controller.
3. Insert the SMOR boot disk and power on the system. This will start SMOR.
NOTE: The SMOR boot disk image is available from the Adaptec Technical Support site.
The download file contains the disk image and instructions for use.
4. Use SMOR to update the firmware. You must restore all three components of the
flash ROM, firmware,
5. Power-off the system and return the jumpers to their original positions.
6. Insert the card in a host system PCI slot.
7. Remove the SMOR boot disk from your floppy disk drive and power-up the
system.
Problem 16
After an upgrade of the
displays the message:
Card not configurable.
Solution 16
Perform a full firmware upgrade for SMOR to correct this condition.
HP 2100S SCSI RAID Controller User Guide
BIOS, and SMOR.
I O
2
BIOS only, pressing Ctrl+A at the system prompt
I O
2
Troubleshooting
C-9