Denon ADV-M51 Operating Instructions Manual page 96

ENGLISH
4
2 "LPCM SELECT (96 kHz / 48 kHz)" is selected.
• OFF (Factory default)
Make the selection when playing back to a decoder DVDs
that were recorded with this unit using linear PCM 48
kHz/20/24 bit and 96 kHz modes. Note that DVDs with
Copyright Protection are converted to 48 kHz/16 bits and
played back.
The same signal is output from the digital output jacks.
• ON
DVDs that were recorded with linear PCM 48 kHz/20/24
bit and 96 kHz modes are all converted to 48 kHz/16 bits.
Make this selection at the time of digital recording.
To exit the LPCM select mode
Press the ENTER button, you can go back to the previous
screen.
NOTES:
• When playing Dolby Digital/DTS surround DVDs or 96 kHz linear PCM DVDs on the ADV-M51, be sure to set "Digital Output" to "Normal"
and "LPCM Conversion Mode" to "Do Not Convert".
• When and only when you want to output the signals of the Dolby Digital/DTS surround DVD being played on the ADV-M51 to a digital
PCM device, set "Digital Output" to "PCM Conversion".
With this setting, DVDs cannot be played on the ADV-M51 in the Dolby Digital/DTS surround mode. (The surround mode is set to the
mode in which PCM 2-channel signals can be played.)
• When and only when you want to make a digital recording of the signals of a 48 kHz/20-bit/24-bit or 96 kHz linear PCM DVD being played
on the ADV-M51 onto a digital recorder, set the "LPCM Conversion" to "Convert".
With this setting it is not possible to decode and play 48 kHz/20-bit/24-bit or 96 kHz linear PCM signals on the ADV-M51 during recording.
(Decoding and playback is in 48 kHz/16-bit linear PCM format.)
96
AUDIO SETUP
LPCM(44.1kHz/48kHz)
Remote control unit
d
ENTER
SELECT :
Remote control unit
OFF
ON
DECISION : ENTER BUTTON