Remote Control Battery Installation And Replacement - Hitachi 32HDT20 Operating Manual

Check to make sure you have the following accessories before disposing of the packing material.
REMOTE
CONTROL
POWER
VCR CBL
TV
STB
SOURCE WIZARD
CD
TAPE
DVD AMP
1 2 3
4
5 6
7 8 9
0
SLEEP INFO
A/V NET
SELECT
VOL CH
VID 3
PIP PIP CH FREEZE
PIP ACCESS
SWAP
PIP MODE VIDEO
REC
CLU-5723TSI
1.
SPEAKER ACCESSORIES
(42HDT20 ONLY)
6.
CAUTION: The plasma display wall mount unit WM20 is for use only with Hitachi model 32HDT20 and 42HDT20.
1. Remote Control Unit CLU-5723TSI (P# HL01823).
2. Two "AA" size, 1.5V batteries (P# EQ00021).
3. Two Power Cords (P# EV00832).
4. Monitor Connection Cable (P# EW07193).

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1. Open the battery cover of the remote control by pushing the notched part of the cover with your fingers and pulling the
cover off.
2. Insert two new "AA" size batteries for the remote control. When replacing old batteries, push them towards the springs
and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.
BATTERIES POWER CORD
2.
WALL MOUNT UNIT WM20
(OPTIONAL)
7.
MONITOR
CONNECTION CABLE
3.
32HDT20 TV STAND SPD32
(OPTIONAL)
8.
5. Two IR Mouse cables (P# EY01641).
6. Speaker Accesories (42HDT20 only).
7. Wall Mount Unit WM20 (Optional).
8. 32HDT20 Stand (P# H520441) (Optional).
4
ACCESSORIES
IR MOUSE
CABLE
4. 5.
BOTTOM VIEW
Lift up on tab to
remove back cover.