Hitachi 32HDT20 Operating Manual page 14

The exact arrangement you use to connect the VCR, camcorder, laserdisc player, DVD player, or HDTV Set Top Box to your Plasma
TV is dependent on the model and features of each component. Check the owner's manual of each component for the location of
video and audio inputs and outputs.
The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your
particular assortment of components and features. For best performance, video and audio cables should be made from coaxial
shielded wire.
Before Operating External Video Source
The input mode is changed when the VID1~VID5 button is pressed as shown below. Connect an external source to the INPUT
terminal, then press the VID1~VID5 button as necessary to view the input source. (See page 30)
CONNECTING A MONAURAL AUDIO SOURCE TO INPUT2~INPUT5
1. Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack, as shown on the AVC
Center below.
2. Connect the cable from the AUDIO OUT of the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO) jack.
3. Press the VID2~VID5 button to view the program from the VCR or the laserdisc player. The VIDEO mode disappears
automatically after approximately four seconds.
4. Press the ANT button to return to the previous channel.
CONNECTING EXTERNAL VIDEO SOURCES
INPUT MODE SELECTION ORDER
(ANTENNA)
Ant A
Rear Panel of AVC Center
ANT A
MONITOR
INPUT 4 INPUT 3
OUT
S-VIDEO S-VIDEO S-VIDEO
TO
CONVERTER
VIDEO VIDEO VIDEO
(MONO) (MONO) (MONO)
L L L
ANT B
R R R
AUDIO AUDIO AUDIO
AUDIO OUT
VCR
Hitachi Model or
Similar Model
(INPUT)
VID1
ANT
RGB 1 RGB 2
ANALOG INPUT DIGITAL INPUT
AUDIO
INPUT 2 INPUT 1
Y/VIDEO
Y
R
AUDIO AUDIO
P (MONO) P (MONO)
B B AUDIO
L L R
P P
R R
AUDIO
R R R
AUDIO OUT
VIDEO OUT
14
YP P :1
B R
VID1
TO MONITOR
L
IR
BLASTER
L
L