Care And Cleaning - Creda HB51S Installation And User Instructions Manual

Care and Cleaning

90
Cleaning materials
to avoid
Ceramic hob
(EDC / ETCW51)
Electric sealed hot-
plates
(ETW51)
26
TURN OFF THE MAIN SWITCH BEFORE CLEANING.
BEFORE SWITCHING ON AGAIN, ENSURE THAT ALL CONTROLS
ARE IN THE OFF POSITION.
NEVER USE BIOLOGICAL WASHING POWDER, HARSH
ABRASIVES, SCOURING PADS, AEROSOL CLEANERS OR OVEN
CHEMICAL CLEANERS OF ANY KIND UNLESS
SPECIFIED BELOW.
1. Plastic or nylon pads / scourers, these may scratch the surface.
2. Household abrasive powders.
3. Oven chemical cleaners, aerosols and oven pads.
Caustic cleaners such as these will etch the surface and attack the
metal frame.
4. Bath and sink cleaners may mark the surface.
To reduce the amount of cleaning always ensure that the hob and cook-
ing utensils are clean and dry before use. Regular use of cleaner condi-
tioner is recommended for proper care and protection of the hob sur-
face. Apply conditioner before using the hob for the first time. It contains
a mild cleaning agent, so that subsequent applications may clean off soil
and apply a protective film at the same time. For stubborn stains or
heavy soiling use any of the following materials, and finish off with con-
ditioner.
1. Jif, non-scratch scouring cream.
2. Liquid Gumption Kitchen Cleanser.
3. Special Powder Cleanser.
Powder Cleanser – Mineral deposits that are present in hard water, and
some foods, may cause 'discolourations' that appear in the form of grey
or brown stains. The stains sometimes appear to be in or under the glass
surface. If there are some persistent stains after using any of the other
recommended cleaning materials, powder cleanser may be applied, fol-
lowing the manufacturers instructions. Do not use abrasive cleaners or
the powder cleanser on the painted metal framework.
Cleaner Conditioner – Regular use of the conditioner will make the sur-
face easier to clean thus ensuring that years of heavy abrasive cleaning
do not progressively dull the surface.
The cleaning of sealed hotplates should be done when they are cold,
using a soap filled Brillo pad, following the grain of the hotplate. This will
ensure that any stubborn, burnt on spillages are removed. Wipe over with
a damp clean cloth, making sure that all the cleaner has been removed.
Finally, turn on hotplate to warm for a few minutes, then smear with a
little cooking oil to provide a protective coating, or the restorative agent
Homecare Four Hob, available from Credacare Spares or leading
supermarkets. The bezels will mellow with use to a burnished gold colour,
a soap filled Brillo pad will help to keep them bright, care should be taken
not to damage the vitreous enamel hob surface.
Note: We do not recommend the use of decorative covers over the hot
hotplates as these can hold condensation and cause corrosion. Accidental
operation with a cover in place can cause intense heat. Never place
saucepan lids on the hotplates, as this may cause corrosion.