Care & Cleaning / Battery Replacement - Creda HB41304 Use & Installation Instructions Manual

CARE AND CLEANING
REPLACING A BATTERY
The battery is not covered by the guarantee. Use an alkaline AA battery. The battery
holder is located in the plinth panel below the oven door. Open the oven door fully.
Unscrew the knurled fixing screw anti - clockwise and remove. Withdraw the battery
holder just enough to get access to the battery.
Fit the new battery with the end marked "+" on the same side of the battery holder as
the red lead. Replace the battery holder by placing it into the hole in the plinth and
sliding to the left. Refit the screw.
Battery
Knurled
Holder
Screw
Clean the cooker regularly and wipe up spills soon after they occur to prevent them from
becoming burnt on. Never use biological washing powder, caustic cleaners, harsh
abrasives, scouring pads, aerosol cleaners or oven chemical cleaners of any kind.
To move the cooker forward, open the grill door and with both handspositioned under the roof
of the compartment, lift and pull forward. Replace by pushing the cooker backwards. Check that
the cooker is level. Take care to ensure that any floor covering is not damaged.
Do not attempt to lift the product using the grill door or door handle.
OVEN HEAT CLEAN LININGS
The oven back and side linings are coated with a special enamel which has a continuous
cleaning action. The higher the oven temperature the more effective the action. In most
cases this cleaning operation will proceed during normal cooking. However, if roasting is
done frequently, or high temperatures are not used regularly, it may be necessary to run
the oven empty at Mark 8 for about two hours. If desirable, they can be washed with
warm soapy water followed by a rinse.
Plinth
15