Connecting The Unit - Lexicon MPX 110 - REV 1 Manual

Getting Started

CONNECTING THE UNIT

The INPUT and OUTPUT connectors on the MPX 110 are
1/4 inch unbalanced sockets. Connections should be
made utilizing high-quality shielded cables with 1/4 inch
Tip/Sleeve phone plugs at the end connected to the unit.
The unit produces effects from either mono or stereo
sources. For mono sources, use the RIGHT (MONO)
INPUT. For instruments and stereo sources, use both
inputs. It is recommended to use stereo outputs
whenever stereo inputs are used. Use the RIGHT
(MONO) OUTPUT if mono output is required. The left
and right input signals are combined internally when
only the RIGHT (MONO) OUTPUT is used.
HEADPHONES
The LEFT (PHONES) OUTPUT supplies a stereo signal
adequate to drive headphones, provided no connections
are made at the RIGHT (MONO) OUTPUT. This feature is
included for convenience and practice purposes. It is
intended to provide modest volume.
1-8
FOOTSWITCH
A footswitch connected to the rear panel FOOTSWITCH
connector can be used to control front panel Tap and
Bypass functions. A momentary footswitch can be wired
to a Tip/Ring/Sleeve connector or a stereo Y-connector,
which allows two identical switches to be used.
Note:
Power off the unit prior to connecting the
footswitch. Otherwise, Bypass functions will be
enabled.
Dual-Function Footswitch
A dual-function footswitch with
labels to indicate Tap and Bypass
functions is available at Lexicon
dealers or www.lexicon.com.
Lexicon
BYPASS TAP