Canopy 400 Series OFDM AP and SM
User Guide
An SM has both a configurable Region Code and, once it registers to an AP, an active Region
Code. After an SM registers to an AP, it uses the Region of the AP to determine its DFS behavior
and displays the AP's Region Code on its Home => General Status page, as shown in Figure 7.
The two Region Codes should be the same in normal operation, but will not be the same if, for
example, as shown in Figure 6 and Figure 7, an SM configured with a Region Code of "None" has
registered to anAP with a Region Code of Europe.
Figure 6: Configured Region Code on SM Configuration => General page
Figure 7: Active Region Code on SM Home => General Status page
Version 1, April 2008
Page 22 of 40