Table of Contents
Advertisement
MAINTENANCE
3. Hydraulic Tank:
Use Hydraulic Oil Chevron 1000 THF or an equivalent.
Note: Your ambient temperature and operating conditions may require a different viscosity oil. Please consult
the oil manufacturer for proper specifications.
Slip Clutch
.A slip clutch is incorporated in the PTO driveline. It is designed to slip, absorb the shock load, and protect the
driveline.
After the first hour of operation, the slip clutch should be checked for overheating. After this first check, the slip
clutch should be checked weekly or anytime there is overheating. To adjust the slip clutch, tighten the spring
bolts 1/8 (maximum) turn at a time. Bolts should NEVER be adjusted to the point where the springs are
compressed solid. Minimum spring compression length is 1-1/4".
The slip clutch should be checked periodically and adjusted to compensate for wear. The lining plates are 1/8"
thick when new. Replace after 1/32" wear. If the mower has been idle for an extended period of time, or in wet
weather, before operating check to be sure the friction lining plates are not frozen or rusted together. Should
this freezing occur refer to the procedure described in the "Seasonal Clutch Maintenance" section on the next
page. Seasonal Clutch Maintenance
HYDRO 88 & 96 03/09
Maintenance Section 5-3
©2009 Alamo Group Inc.
Advertisement
Table of Contents
