Vpn Client Configuration - NETGEAR DGFV338 - ProSafe Wireless ADSL Modem VPN Firewall Router Network Setup Manual

VPN client configuration

This configuration requires advanced IP address planning. The VPN client policy needs to be
able to address both Local Area Network #1 and Local Area Network #2 in the same client policy
profile, therefore, the two networks must be presentable as one subnet or one address range.
This has been considered in our scenario.
Create a new VPN client policy
Specify the Remote Party ID type as IP
Subnet and the subnet and mask as
172.22.0.0 255.255.255.0 (this will
address both LAN1 and LAN2)
The gateway IP address will be specified
at the WAN address of the FVX538 in our
case
In My identity change the pre-shared key
to match the VPN policy LAN1toVPN
created on the FVX538 (12345678)
Set the Virtual adapter as Required as
specify a unique value for the Internal
network IP address (this will be different
on each PC running the VPN client
In the Security policy section ensure the
Phase 1 negotiation mode is set to
aggressive , PFS is enabled and Enable
Replay Detection is ticked
Version 1.0