Advertisement
Quick Links
Advertisement
Related Manuals for Lexicon 960L V2.40 - INSTALLATION AND RELEASE NOTES REV 2
Summary of Contents for Lexicon 960L V2.40 - INSTALLATION AND RELEASE NOTES REV 2
- Page 1 960L Version 2.40 Software Upgrade Installation Instructions & Release Notes...
-
Page 2: Safety Symbols
Fax 781-280-0495 (Sales) Fax 781-280-0499 (Service) This document should not be construed as a commitment on the part of Lexicon, Inc. The information it contains is subject to change without notice. Lexicon, Inc. assumes no responsibility for errors that may appear within this document. - Page 3 960L Version 2.40 Software Upgrade Installation Instructions & Release Notes These service instructions are for use by qualified personnel only. Do not perform WARNING any servicing other than that contained in these instructions unless qualified to do so. Refer to safety summary prior to performing any service.
-
Page 4: Installation Instructions
Installation Instructions & Release Notes Lexicon This document contains installation instructions for the 960L Version 2.40 Software. It describes updated and enhanced features of Version 2.40, and discusses items that did not receive full coverage in the Owner’s Manual. Please refer to the 960L Owner’s Manual for additional information. - Page 5 Installation Instructions & Release Notes 960L Version 2.40 Software 3. Remove the CD from the drive. Power down the system, wait a few seconds, then power back up. The 960L will take a little longer to boot than normal. If the LARC2 requires an update, the LARC2 will display the following menu: Update needed on Larc2: Press ’1’...
-
Page 6: Reverting To A Previous Software Version
Installation Instructions & Release Notes Lexicon REVERTING TO A PREVIOUS SOFTWARE VERSION To revert to a previous version of 960L software, follow the same procedure outlined above using the release CD for the desired software version. There is one special consideration: When upgrading to Version 2.40, the software recognizes prior versions of user registers and... -
Page 7: Release Notes
Installation Instructions & Release Notes 960L Version 2.40 Software RELEASE NOTES The list below includes features of the 960L Software Version 2.40 that are not fully covered in the Owner’s Manual: • When configuring systems with two DSP cards, there are no longer two soft buttons labeled CONFIG 1 and CONFIG 2. - Page 8 A Harman International Company Lexicon, Inc. 3 Oak Park Bedford, MA 01730-1441 USA Tel 781-280-0300 Fax 781-280-0490 www.lexicon.com Customer Support Tel 781-280-0300 Fax 781-280-0495 (Sales) Fax 781-280-0499 (Service) Lexicon Part No. 070-14818 | Rev 2 | 07/01...