Alamo Industrial Exten-A-Kut II Operator's Manual page 132

Streaking Conditions
Blade Bolts
Blades Wears Too Fast
EK II 03/09
©2009 Alamo Group Inc.
OPERATION
Conditions too wet for
cutting.before cutting.
Dull blades.
Height of cutter lower at
rear or front.
Bolts not tightened.
Bolt hole elongated or
oversized.
Locknut worn out.
Cutting in sandy conditions.
Cutting in rocky conditions.
Operation Section 3-40
Allow grass to dry
Slow
ground speed of
tractor but keep
engine running at full
PTO rpm. Cutting
lower may help.
Sharpen or replace
blades.
See Cutting Height
Instructions.
Tighten bolts to
350 ft.lbs.
Replace Bushing or
Blade Carrier.
Replace Locknut.
Increase cutting height.
Increase cutting height.