Advertisement
3. Reconnect the power cord and turn ON the main power switch located on the back of the FT-2000
(or turn ON the power supply for FT-2000D).
4. While holding the [DNR]＋[CONT]＋[DNF] buttons, press the front power switch to turn the
radio on. You will see
5. On your computer desk top open PEP2000_EDSP folder and find the EDSP-301 icon as shown
below. Double-click the EDSP-301 icon, displayed on the Program Screen.
6. Click the Update button. You will see AH025H_V1154 out file displayed. If you do not see
AH025H_V1154 (as in the screen below), then open the "Look in:" window and go to the desktop
and find PEP2000_EDSP. Open the folder and AH025H_V1154 will be displayed in the
window. Click AH025H_V1154 out file to
the program is loaded, and 100% is indicated on the bar graph, [completion!!!] will be displayed.
7. Turn the front Power Switch and the Main Power Switch in the back OFF (or turn off the power
supply for FT-2000D and wait a minute, until the capacitors discharge) and remove the AC power
cord. This resets the radio and locks in the new software. Remove the DB9F to DB9F cable. The
updating process is now complete.
It is important to reset the FT-2000/D. Plug the radio back in. Press and hold in the [FAST] and
[LOCK] keys; while holding them in, turn the radio back on (this resets the radio and locks in
the new software).
[dSP Prg NO
1] on the radio display.
highlight
it. Then click the Open button and wait until
NOTE: If you receive a "communications
error" message on your screen you should
check the COM port number and speed under
Device Manager. The writing speed
38.4kbps is fixed in the download algorithm
of the EDSP board so you may need to set
the port speed close to 38.4kbps. Click on the
COM Select box arrow and choose a
different COM port from the drop down
menu in the EDSP-301 writer.
Advertisement
