Download Print this page

Alamo Industrial Axtreme 02984405 Assembly Manual page 16

Alamo industrial boom arm mower assembly manual

Advertisement

SPECIFICATIONS - AXTREME BOOM
READ THIS BEFORE BEGINNING ASSEMBLY:
The Axtreme Boom has electronic components:.
be damaged if care is not taken when performing repairs, testing and/or during assembly.
DO NOT
1.
DO NOT
short any wires across or allow them to be shorted out.
2.
DO NOT
attempt to jump across any wires or supply them with alternate power source.
3.
DO NOT
install higher rated fuses than are recommended by manufacturer.
4.
DO NOT
do any welding on unit unless the computer modules are unplugged first, this is to prevent a power
surge going into modules (THIS IS VERY IMPORTANT). This could also apply to the tractor components.
Check Tractors repair guide for specific instruction about tractor model and type.
5.
DO NOT
attempt to repair or adjust a component that is not intended to be repaired, example sealed
components as there are no serviceable components inside.
6.
DO NOT
let anyone attempt any testing or repairs unless they are an experienced and qualified techni-
cian. Technicians must have proper tools, gauges, meters etc. to perform proper diagnosis and/or repairs.
7.
DO NOT
perform any assembly or repairs with dirty tools or in dirty work area. When working on hydraulic
components keeping system clean and free of contamination is important.
8.
DO NOT
start or engage system if the oil level is not at the proper level or condition. Never start or run
unit low or out of oil.
9.
DO NOT
install / add any oil unless you know it is the correct type and the container is clean. Make certain
the oil is not contaminated with dirt or any liquid.
1.
Pump Specifications:
Body Construction.....................................................................Cast Iron
Control Valve Type.................................................................... Direct Acting, Pilot Operated
Control Valve Relief................................................................... 3000 PSI
Driveshaft Type......................................................................... 1" X 15 Spline
Driveshaft Torque Rating............................................................ 371 ft. lbs.
Pressure Rating (Maximum)....................................................... 3000 PSI
Pump Type............................................................................... Gear
Pump Gear Width..................................................................... 2 inch
Pump Efficency Flow Rate (Approx)............................................ 85 % of G.P.M. is Acceptable
Speed Rating (Maximum)...........................................................2400 RPM
Nominal Displacement (Per Revolution)....................................... 5.1 Cu. In.
Output @ 1800 RPM.(Operating RPM)........................................ 37.5 G.P.M.
Output @ 2400 RPM.(Maximum RPM)........................................51 G.P.M.
Horsepower Rating (Maximum Conditions)...................................90 HP
Rotation Direction (Viewed from Top of Deck................................Clockwise
Motor Start / Stop Time............................................................. 6 Seconds (Approx)
Tank Capacity Required............................................................. 17.5Gallons
Oil Type................................................................................... See Oil Chart
Oil Temperature (While Operating).............................................. 70 Deg, (F) Above Ambient
Axtreme Boom - Asy Man (07/06)
© 2006 Alamo Industrial
The electronic components can
Section 2 - 2

Advertisement

loading

This manual is also suitable for:

Axtreme