Receive One Program; Request Ram Area - 06 - DigiTech SDISC SYSEX1.25 Manual

Procedures
Procedures
RECEIVE ONE PROGRAM (42h)
SYS_HEAD 42
When yy = 00
When yy = 01
dd(n) 0000000v
1
dd(n) 0vvvvvvv
2
The Receive One Program procedure is used to load a program into the DigiTech
device. The number of program bytes to be received (n) is different for each program. If
the Digitech device is sent a Receive One Program procedure where the program
number is not a valid RAM destination, it will be ignored. For examples of each
product's actual information format, please see Misc Information (page 20).
REQUEST RAM AREA (06h)
SYS_HEAD, 06
bb Bank number of ram being requested.
ww 0000000v
xx 0vvvvvvv
yy 0000000v
zz 0vvvvvvv
nn 1 to 7F
The Request RAM Area procedure is used to have the DigiTech device send an area of
its internal ram to a host midi device. When a Request RAM Area procedure is
received, the DigiTech device will respond with a Data Response procedure. Use the
address information from the Receive Configuration Address procedure to identify the
RAM locations which may be accessed from the various products.
6
6
, yy, zz, dd(1 ) dd(1
st 1
(h)
, then zz = Program numbers 1 through 128 (00-7Fh)
(h)
, then zz = Program numbers 129 through 256 (00-7Fh)
(h)
where v is bit 7 of the n
(b)
where v is bits 6 through 0 of the n
(b)
, bb, ww, xx, yy, zz, nn, F7
(h)
where v is bit 15 of the ram address.
(b)
where v is bits 14 - 8 of the ram address.
(b)
where v is bit 7 of the ram address.
(b)
where v is bits 6 - 0 of the ram address.
(b)
, the number of ram bytes to be sent.
(h)
) , ... dd(n ) , dd(n ) , F7
st 2 th 1 th 2
byte of the received program.
th
byte of the received program.
th
(h)
DigiTech S-DISC™ SysEx
DigiTech S-DISC™ SysEx
(h)